Committee Draft
ISO/CD 12129-2
Plain bearings — Tolerances — Part 2: Tolerances on form and position and surface roughness for shafts and thrust collars
Reference number
ISO/CD 12129-2
Edition 3
© ISO 2024
Committee Draft
Under development
A draft is being reviewed by the committee.
Will replace ISO 12129-2:2019

Abstract

This document specifies tolerances on form and position as well as the surface roughness of shafts, flanges and thrust collars as used in plain bearing units. It is applicable to journal or thrust plain bearing units or to a combination of both, installed either horizontally or vertically.

This document is not applicable to crankshaft bearing units in combustion engines.

General information

  • Status
     : Under development
    Stage
    : CD approved for registration as DIS [30.99]
  • Edition
     : 3
  • Technical Committee :
    ISO/TC 123/SC 3
  • RSS updates

Life cycle

Got a question?

Check out our Help and Support

  2. Store
  3. Standards catalogue
  4. ICS
  5. ISO/CD 12129-2