ISO 11992-1:2019
2019-05
ISO 11992-1:2019
Résumé
This document describes the data link layer (DLL) and physical layer (PHY) for the two CAN-based network interfaces specified in the 11992-series.
The DLL sub-clauses are composed of:
— DLL protocol entity requirements;
— DLL device interface requirements; and
— DLL network system requirements.
Normally, the physical signalling sub-layer is implemented in the CAN protocol controller. The physical medium attachment sub-layer is normally implemented in the CAN transceiver or the System Base Chip (SBC). Optionally, it can comprise also additional protection circuitry. The media-dependent sub-layer comprises the connectors and the cabling.
The physical signalling (PS) sub-clauses are composed of:
— PS entity requirements;
— PS device interface requirements; and
— PS network system requirements.
The physical medium attachment (PMA) sub-clauses are composed of:
— PMA protocol entity requirements; and
— PMA device interface requirements.
The physical medium dependent (PMD) sub-clauses are composed of:
— PMD entity requirements;
— PMD device interface requirements; and
— PMD network system requirements.
Informations générales
-
État actuel: PubliéeDate de publication: 2019-05Stade: Clôture de l'examen [90.60]
-
Edition: 3
-
Comité technique :ISO/TC 22/SC 31ICS :43.040.15
- RSS mises à jour
Cycle de vie
-
Précédemment
AnnuléeISO 11992-1:2003
-
Actuellement
PubliéeISO 11992-1:2019
Les normes ISO sont réexaminées tous les cinq ans
Stade: 90.60 (En cours d'examen)
