Résumé
This document specifies a system of fits applicable to metallic plain bearings used in general engineering for mean relative bearing clearances, ψm, of 0,56 ? up to 3,15 ?. Other clearance ranges can be used depending upon the requirements in specific applications.
This system of fits is not applicable to half‑bearings and bushes which, due to their special characteristics, are not measured by diameter but by wall thickness, and which are dimensionally changed on assembly. It is not applicable to profile bore or tilting pad bearings, or to cases where specific tolerances have been established by consideration of the bearing performance at both extremes of clearance.
This document is applicable preferably to rotating machine parts and shafting, but it can be used similarly in other ranges of application.
Informations générales
-
État actuel: PubliéeDate de publication: 2019-03Stade: Norme internationale à réviser [90.92]
-
Edition: 2
-
Comité technique :ISO/TC 123/SC 3ICS :21.100.10
- RSS mises à jour
Cycle de vie
-
Précédemment
AnnuléeISO 12129-1:1995
-
Actuellement
PubliéeISO 12129-1:2019
Les normes ISO sont réexaminées tous les cinq ans
Stade: 90.92 (Sera révisée) -
Sera remplacée par
ProjetISO/FDIS 12129-1